Firmware Update and Install Procedure

Prior to executing this procedure, read the Important Notices section of the release notes.

The eGrabber driver comes with all the firmware variants for all the CoaxlinkEuresys product series name of CoaXPress frame grabbers cards.

1.

Determine the firmware variant that fulfills the functional requirements of your application: e.g. '1-camera', '1-camera, line-scan', '2-camera'. Therefore, check the Firmware Variants per Product section of the release notes for the firmware variants that are applicable to your card.

2.

Launch the Firmware Manager tool to perform a firmware update or to install a specific firmware variant on your card(s) using the Firmware Manager tool in GUI mode or in command-line mode:

a.

In GUI mode, to update or install a variant:

Select the card to update

Select the firmware variant to install

Proceed with the installation

b.

In command-line mode, to update a variant: coaxlink-firmware update

c.

In command-line mode, to install another firmware variant: coaxlink-firmware install '[variant-name]'

3.

Wait until completion of the firmware update

Avoid turning off your PC during the firmware update procedure!

4.

Repeat the procedure on all your Coaxlink cardsEuresys CoaXPress frame grabber.

5.

Power off completely your PC and restart it to activate the newly loaded firmware.